 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|
|
|
|
|
|
This constraint specifies a square check around shapes on layer 1. Any outer vertices on layer 2 shapes must be seperated by a minimum distance from the edges of layer 1 shapes. This layerPair constraint is not symmetric.
| Constraint type: | oaLayerPairConstraint (Symmetric: no) |
| Value types: | oaIntValue |
| Database types: | oaDesign, oaTech |
| Object types: | oaAppObject |
The following value types are supported by this constraint:
This value specifies the required minimum spacing in database units.
Units: DBU
This constraint ensures that the metal should overlap the cut by a sufficient margin.
Copyright 2002 - 2010 Cadence Design Systems, Inc.
All rights reserved.